How do I spilt the cable going to my modem and run it to my TV and get a signal on both? - cable tv modem
Recently, I canceled my cable TV, but I kept my cable Internet. I was curious and ran the cable from the modem directly to a TV to see whether it is a sign. I had nothing, but I've heard that people receive through their cable division and a signal to the TV and modem. What are all supposed to do?
Thursday, January 14, 2010
Cable Tv Modem How Do I Spilt The Cable Going To My Modem And Run It To My TV And Get A Signal On Both?
3 comments:
Go to your local cable companies like Comcast and tell them you want to rent a box for basic cable. So that you can get basic cable, which is free, too. The few channels, but it is something.
Go to the electronics store like Radio Shack and buy a TV splitter. Run a cable from the wall in the separator, and a cable modem and cable to basic cable, and a final cable from your cable box to your TV.
The Fund should not rent more than $ 2 per month.
It ....
If your cable service has hardly qualified internet service has been reduced to cable TV has been encoded by a filter on the pole, PED, or a zone plate, depending on what kind of house we live in This filter is designed to encode all frequencies, with the exception of two or three frequencies for the use of Internet services. Some cable companies use some frequencies in the band of low for television and Internet services. At this level, most filters can not receive all these channels that some stations are available for viewing. Believe me, the cable companies are not stupid, has the design of these systems is one reason. So, in other words ... Depending on your cable, most cable systems are preventing the Internet at the following channels of theft of service channels 116, 125, 124, 123, 115, 01, 02, 03, and 99 channel ..
Well, if you want to spit a line to your TV and your modem, you need a two-way splitter. Make sure that the appropriate delimiters. Kraft just go buy at Radio Shack and all two-way splitter. The splitter 5-1000 MHz, you must neither more nor less. When you receive is connected, then you can use the channels on your TV scan to see if you get something. Good luck .. Oh, if you want to remove cable channels to get the filter poles, PED, or a zone plate. Hope this helps
The cable company delivers a television signal via cable more than the fact that plugging the cable directly to the TV shows nothing. Adding a splitter to send a signal that, if not to start it.
Post a Comment